Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 2 Current »

Use the procedure in this section if you want to manually install a VirtaMove Source Agent on each source server.

If you have a large number of servers on which you want to install Source Agents, VirtaMove recommends using V-Maestro to install Source Agents remotely. To install Source Agents remotely using the V-Maestro interface, see Installing Source Agents Remotely Using V-Maestro.

Pre-Requisites

  • Ports TCP 137, 139, and 445 must be open to install VirtaMove Source Agent.

  • Port 9665 must be open to connect to the VirtaMove Source Agent on the source machine.

Note:
You can verify the integrity of your downloaded software by checking the MD5. See here for more details.

To Install a Source Agent Manually

  1. On the machine where you want to install a Source Agent, run one of the following installers:

    • VirtaMoveSourceAgent_x86.msi (for 32-bit servers)

    • VirtaMoveSourceAgent_x64.msi (for 64-bit servers)

  2. The installer opens. Accept the license agreement.

  3. Select a key. See About SSL Keys for more information.

  4. Repeat this procedure for each server where you want to install a Source Agent.

  • No labels